Are you looking to replace your Pentair 79212165 Gray Large Plastic Snap-on Face Ring? If so, you’ve come to the right place. This blog post will walk you through the steps of replacing your Pentair face ring.
First, you’ll need to locate the old face ring. This should be located on the front of your Pentair pool filter. Once you’ve located it, you’ll need to remove it. You can do this by gently pulling it away from the filter. Once the old face ring has been removed, you’ll need to clean the area where it was attached. This will ensure that the new face ring has a secure fit. Use a soft cloth and a mild detergent to scrub away any dirt or debris. Once the area is clean, you can move on to the next step.
Next, you’ll need to get your new Pentair 79212165 Gray Large Plastic Snap-on Face Ring. Make sure that it is the correct size for your filter. Once you have the correct face ring, you can begin the installation process. To install the new face ring, insert the tabs on the face ring into the slots on the filter. Then, press down firmly to ensure that it is securely attached. Once the face ring is in place, you can replace the O-ring and the cover.
Finally, you’ll need to check the filter pressure and make sure that the new face ring is working properly. If the filter pressure is too high or too low, you may need to adjust the pressure.
Congratulations, you’ve successfully replaced your Pentair 79212165 Gray Large Plastic Snap-on Face Ring! With these simple steps, you can keep your filter running in top condition.
If you have any other questions about pool and spa products please do let us know - we are here to help!
Also don't forget to subscribe to our YouTube channel and check out our videos with other great pool and spa products!