Are you looking to spruce up your pool with a new Pentair 79213111 Black Large Plastic Snap-on Face Ring? Installing the face ring is easy and can be done by anyone with basic DIY skills.
In this blog post, we’ll go over the steps to install the Pentair Plastic Snap-on Face Ring.
Step 1: Preparing the Area
The first step is to prep the area where you’ll be installing the face ring. Make sure the area is clean and free of any debris. If the area is not clean, use a damp cloth to remove any dirt and grime.
Step 2: Measuring and Aligning the Face Ring
Once the area is prepped, measure the area where you’ll be installing the face ring. Use a tape measure or ruler to get the exact measurements of the area. Then, align the face ring with the measurements you took. Make sure the face ring is aligned properly before you move on to the next step.
Step 3: Installing the Face Ring
Once the face ring is aligned, you can start installing it. Start by using a screwdriver to remove the screws that hold the face ring in place. Once the screws are removed, position the face ring in the desired location and use new screws to secure it in place. Make sure the screws are tightened securely.
Step 4: Finishing Up
Once the face ring is installed, you can finish up by applying a sealant or caulk around the edges of the face ring. This will ensure a watertight seal and prevent any water from entering the area.
And that’s it! You’ve successfully installed your Pentair 79213111 Black Large Plastic Snap-on Face Ring. Now you can enjoy your newly updated pool area!
If you have any other questions about pool and spa products please do let us know - we are here to help!
Also don't forget to subscribe to our YouTube channel and check out our videos with other great pool and spa products!