How to Replace Pentair 619601Z Face Ring

If you have a Pentair 619601Z Pool Filter and need to replace the face ring, then this blog post is for you! Replacing the face ring on a Pentair 619601Z Pool Filter is not a difficult process, but it does require some special tools and knowledge. This blog post will provide you with step-by-step instructions on how to replace the face ring on your Pentair 619601Z Pool Filter.

First, you will need to obtain the correct replacement face ring for your Pentair 619601Z Pool Filter. Make sure to check the size and model of your filter before ordering the correct replacement part.

Once you have the correct part, the next step is to locate and remove the existing face ring. This can be done by unscrewing the four screws that hold the face ring in place. Once the screws have been removed, carefully pull the face ring off of the filter.

Next, you will need to install the new face ring. Begin by aligning the notches in the new face ring with the notches in the filter. Once aligned, insert the four screws back into place and tighten them securely.

Finally, you will need to re-install the filter cover and secure it in place. Once the cover is in place, your Pentair 619601Z Pool Filter is ready to be used again.

Replacing the face ring on a Pentair 619601Z Pool Filter may seem intimidating at first, but with the right tools and knowledge, it is a relatively straightforward process. Make sure to double check the size and model of your filter before ordering the correct replacement part, and follow the steps outlined in this blog post to ensure a successful installation.

If you have any other questions about pool and spa products please do let us know - we are here to help! 

Also don't forget to subscribe to our YouTube channel and check out our videos with other great pool and spa products!

Leave a comment