Are you looking for a way to install the Pentair 79212111 Black Large Plastic Snap-on Face Ring? If so, you’ve come to the right place! In this blog post, we’ll show you the easy steps for installing this type of face ring.
Before you begin, make sure that you have all the necessary tools and supplies on hand. You’ll need a Phillips screwdriver, a pair of pliers, and the Pentair Black Large Plastic Snap-on Face Ring.
Step 1: Begin by removing the existing face ring from your pool or spa. This can be done by unscrewing the four screws that hold the face ring in place.
Step 2: Once the existing face ring is removed, clean the area where you’ll be installing the new face ring. This is important because any dust or debris will interfere with the installation process.
Step 3: Take the new face ring and insert it into the hole in the pool or spa. Make sure that the two tabs on the back of the face ring are lined up with the corresponding slots in the hole.
Step 4: Secure the face ring in place by using the four screws that were removed in step one. Use the Phillips screwdriver to tighten them down.
Step 5: Finally, use the pliers to secure the face ring by pressing down on the tabs until they snap into place.
And that’s it! You’ve successfully installed the Pentair 79212111 Black Large Plastic Snap-on Face Ring. We hope this blog post has been helpful in showing you how to install this type of face ring. If you have any questions, please don’t hesitate to contact us.
If you have any other questions about pool and spa products please do let us know - we are here to help!
Also don't forget to subscribe to our YouTube channel and check out our videos with other great pool and spa products.