Are you looking to replace the rear hub assembly on your Pentair pool pump? If so, you’re in luck! Installing the Pentair 78232400 3/4-Inch Rear Hub Assembly is a simple process that can be completed in just a few easy steps.
Step 1: Shut off the power to the pump. Before beginning any installation or maintenance project, it’s important to ensure that the power is off. This will help to prevent any possible electric shock.
Step 2: Remove the old rear hub assembly. To do this, use a wrench to unscrew the four bolts that hold it in place. Once the bolts are removed, carefully pull off the assembly from the pump housing.
Step 3: Clean the area where the new assembly will be installed. Use a damp cloth to remove any debris or dirt that may have accumulated.
Step 4: Install the new hub assembly. Place the assembly into the pump housing and secure it using the four bolts. Make sure to tighten them securely.
Step 5: Turn on the power to the pump. After the installation is complete, you can turn the power back on and check to make sure the assembly is working properly.
By following these simple steps, you can easily install a Pentair 78232400 3/4-Inch Rear Hub Assembly. With this new assembly in place, your Pentair pool pump will be back up and running in no time!
If you have any other questions about pool and spa products please do let us know - we are here to help!
Also don't forget to subscribe to our YouTube channel and check out our videos with other great pool and spa products.